Homework 1: Machine Proficiency & Calibration

Goal: Master the physical machine setup and achieve the perfect “cut depth.”

Assignment

1. Blade Height Setup: Using the # method covered in the course, set your blade to a generic height suitable for cutting adhesive vinyl.
2. Test Cut Routine:
3. Load a small piece of scrap adhesive vinyl into your machine.
4. Perform a small test cut using the test button.
5. Examine the cut: Did it cut the vinyl but leave the backing paper intact?
6. If the cut was imperfect, adjust the machine force (pressure) on the machine and repeat the test cut in a new location until you achieve the perfect “kiss cut” (perfect cut).
7. Large Material Prep: Load a roll of vinyl, ensuring the pinch rollers have the correct tension and all slack is removed, verifying the machine’s ability to track long material straight.

Submission

Submit one photo showing your successful test cut square cleanly weeded from the scrap material, leaving the backing paper intact.